The extruder is heated to 200-220 degrees for 1.5-2 hours, depending on the grade of the material. The four and five areas of the machine head are the backup areas. After the temperature reaches the temperature, after the host mold and the molding machine have found a balance, the frame level of the machine tool is To make sure it is accurate, place the level on the mold to level it. After leveling, be sure to tighten the 12 screws on the left and right sides of the mold. If it is not leveled, the material will not come out and the machine head will rub against the mold. There are up, down, left and right adjustment screws on the molding machine.
When leveling, you must ensure that it is most accurate to push out a little material after preheating and then find the balance.
Adjust the deflection of the outer wall, and then use a circle of large screws on the heating belt on the machine head. Which side of the outer wall is thicker, which side is tighter, and which side is looser; adjust the deflection of the inner wall, and then there are 4 small screws on the die, which side Which side is thinner? The inner wall and outer wall are opposite.
Recommended products
Single Wall Corrugated Pipe Production LineThe corrugated pipe produced by Single Wall Corrugated Pipe Production Line is commonly used in various applications such as drainage systems, cable protection, and agricultural irrigation.- Double Wall Corrugated Pipe Production LineDouble Wall Corrugated Pipe Production Line is a type of manufacturing equipment used to produce double wall corrugated pipes. These pipes are commonly used in various applications such as drainage systems, sewage systems, cable protection, and telecommunications.
- PE Pipe Production LinePolymer, a chain of monomers is versatile which has led to the versatility of the plastic products. The horizon of the plastic products is broad. One of these versatile plastic products is a high density polyethylene pipe which delivers safe and clean water. These pipes with its numerous advantages has benefited the society with advantages such as chemical resistance, corrosion resistance, no toxicity, longer life cycle, better impact strength, light weight, lower installation costs, energy savings etc.
Polyethylene Pipes for Entrepreneurs - 110-315mm PE Pipe Gas Water Machine Production LineThe center height of the whole production line equipment is 1100+-50mm to design and produce
We test 315mm pe pipe line with SDR9 well for our Russia customer - PVC Foam Board Production LinePVC Foam Board Production Line can be customized according to customer needs
- TPV Profile Production LineTPV Profile Production Line is used for producting sealing strip of PVC TPU TPE plastic etc material ,features high output ,steady extrusion ,low power consuption.
